C
Computer Bob
I just updated a client to a new XP Pro PC. She was using Access 97 to run
several reports she created. She has a Okidata ML321-Turbo which holds 15"
Wide Tractor fed paper. Her Report uses the US std Fanfold paper size. When
I look at the report in preview, I noticed the right margin was set to 2.11
inches. Therefore it cut off the last two columns of her report. I tried to
change the margin and it reverts right back to 2.11 inches when you click
away. I tried using Generic/Text Drivers and that printed it really goofy
but it did put all of the columns on the page. I am at a loss on how to fix
this. If I design a new blank report in a new database, it does the same
thing. Is this a Access 97 to Windows XP ML321 Drivers issue? It seems like
the only drivers that prints this report legibly is the ML321 drivers but I
just need to get that margin moved over.
Any help is much appreciated and thanks in advance
Bobg
several reports she created. She has a Okidata ML321-Turbo which holds 15"
Wide Tractor fed paper. Her Report uses the US std Fanfold paper size. When
I look at the report in preview, I noticed the right margin was set to 2.11
inches. Therefore it cut off the last two columns of her report. I tried to
change the margin and it reverts right back to 2.11 inches when you click
away. I tried using Generic/Text Drivers and that printed it really goofy
but it did put all of the columns on the page. I am at a loss on how to fix
this. If I design a new blank report in a new database, it does the same
thing. Is this a Access 97 to Windows XP ML321 Drivers issue? It seems like
the only drivers that prints this report legibly is the ML321 drivers but I
just need to get that margin moved over.
Any help is much appreciated and thanks in advance
Bobg