J
JamesHall
I am trying to simulate water flow through a system. On the custom shapes i
have created such as pumps, sources and sinks etc i have been able to set the
connection points as either inward or outward. However i am just using
connectors(arrows) to represent pipes and am unable to preset on end as
output and the other as input. The reason for me wanting to do this is to
make sure i don't have two sources connected together as this is obviously
physically impossible. Does anyone have ideas?
Many thanks,
James
have created such as pumps, sources and sinks etc i have been able to set the
connection points as either inward or outward. However i am just using
connectors(arrows) to represent pipes and am unable to preset on end as
output and the other as input. The reason for me wanting to do this is to
make sure i don't have two sources connected together as this is obviously
physically impossible. Does anyone have ideas?
Many thanks,
James