Adding new field to report

[djd011]

Hi again everybody,

I am updating a report by adding a field to it that is tied to a text field
on a table. I have two problems that are occuring.
1. When I run the report a prompt pops up that is labeled "Enter Parameter
Value." If I leave the box blank the Report Runs, but I run into the next
problem.
2. The Test Records I placed in that a few places just to make sure the
report was pulling the correct data is not appearing in the report.
I am not sure why either of these two problems are happening but I would
appreciate any help with this.

Thank you!

 

[djd011]

I placed this in the wrong board by accident. please ignore this,

Thanks,