Auto Fill function in Excel 2007 not working properly

[Raudawg]

I cannot get the Auto Fill function to increase values in a series, and I
feel certain I'm doing it right:

First, I tried typing a series of values in a column like this: Cell A1, I
typed 1. Cell B1, I typed 2. Then, I selected both cells with the mouse, and
then moved to the lower right corner of Cell B1 and left-clicked and held the
mouse button down. Then I dragged the mouse button down several columns. The
little pop-up message seemed to indicate that it was repeating 1, 2, 1, 2.
When I released the mouse button, it had actually filled a 1 in each cell!

After several unsuccessful attempts, I read online help and decided to try
using a different method: the Fill tool function button on the toolbar. I
could not seem to make that command work.

The instructions in Online Help suggested I had a problem. I read, "1. On
the Home tab, in the Editing Group, click Fill, and then click Series." When
I clicked Fill, the Series command was grayed out, apparently regardless of
what I had selected: a blank cell, a series of cells with a series of
increasing values, or a combination of both.

I began to suspect that my program settings were "messed up", so I clicked
the Microsoft Office button, then the Excel Options button near the bottom
right corner of the tab, as it instructed. I reviewed all the settings.
Everything appears to be set properly. For example, Under Advanced options,
"Enable fill handle and cell drag-and-drop" is checked, as is almost every
other option on that tab.

I wondered if there was an configuration problem with my software, so I even
ran the online Microsoft Office Diagnostics. It found no problems, conflicts,
etc.

What am I doing wrong?

 

[Raudawg]

P.S. I had applied filters to the data sheet, and was working deliberately
with one of the filters. I see that if I remove the filters, the function
works.

So that still leaves me with a question: If I want to count the number of
entries in a filtered list, how do I do that? For example, should I use a
formula with something like "COUNT" or "COUNTIF", rather than trying to
simply enumerate the rows?

If so, how do I do that?

I will be eternally grateful for a correct, understandable answer.

Steve

 

[CellShocked]

So that still leaves me with a question: If I want to count the number of
entries in a filtered list, how do I do that?

Highlight the cells you are wanting data on, then look at the status
line at the bottom of the worksheet window. There are several
statistical figures there, including count.

 

[Gord Dibben]

To count autofiltered entries use the SUBTOTAL function.

=SUBTOTAL(3,range)

Will count only visible cells.

As far as autofilling goes.

I generally use this method.

Enter a number in a cell

Right-click on fill handle and drag down.

Release button and "Fill Series" to get a series of numbers.

Otherwise you must have two numbers so Excel can see a pattern.

Enter 1 in A1, 2 in A2

Select both cells and drag down.

The series will fill.


Gord Dibben MS Excel MVP

 

[Linda Huntington]

Regarding the reply from Gord Dibben MS Excel MVP


As far as autofilling goes.
I generally use this method.
Enter a number in a cell
Right-click on fill handle and drag down.
Release button and "Fill Series" to get a series of numbers.
Otherwise you must have two numbers so Excel can see a pattern.
Enter 1 in A1, 2 in A2
Select both cells and drag down.
The series will fill.

If you have an autofilter on, it will not fill. "Fill/Series" is grayed out. It works once you turn your filters off.