Automate Line Jump

[Lil]

Hi there - first time posting - I've been working on a
Visio diagram for a project and for some reason, I don't
get line jumps... Tried the Page Setup and the Layout and
Routing, nothing happened, Tried the Behavior but there is
no tab for line jumps as it is referred in the Help
option... Any help would be appreciated as this diagram is
pretty "congested", the line jump would make it so much
easier. There is the Line Jump in the Connectors template
but want to automate it and not do this manually.

Again, if anyone could point me to the right direction,
that would be great.

Much thanx in advance,
Lil

 

[Mark Nelson [MS]]

Hi Lil,

The most common reason why you wouldn't get line jumps would be that you are
working with Lines instead of Connectors. Unfortunately, Visio
differentiates between the two. In the Standard toolbar, you should see a
Connector tool and a Line tool. Use the Connector tool in your drawing and
you should get line jumps.