Break Point not set, no errors, app enteres debug mode at Previous

[John Bu]

I have an application that breaks into debug mode on a previously set Break
Point, even after having closed and re-opening the application.

It acts as if the break point is still set.

This problem occurs after setting a Break Point and then removing the Break
Point.

What can I do to stop the application stopping at previously set Break Point.

The vba code is in an Access form.

 

[John Bu]

I have found a solution, make a change in the model where it's going into
debug and then press save, once a change is made it does not enter debug
again!