Can't access cells

B

Billy B

I have a problem I haven't seen or heard of before. The workbook I am working
with has cells in a single worksheet that I cannot access once the worksheet
is protected. Here is what I have done. Unprotected the worksheet, unlocked
the cells, made sure the hidden is not selected. I can access all the cells,
modify data, etc like normal. Then, if I protect the worksheet, when I try to
access unprotected cells, my active cell jumps to cell L10 and I can't enter
any data into other cells. I have three other worksheets that are working
fine.

Does anyone have any ideas?

Thank you.
 
M

Ms-Exl-Learner

While Protecting your worksheet check "select unlocked cells" and give
password and give ok.

If this post helps, Click Yes!
 
B

Billy B

Thank you for your help. I had already done what you suggested and it didn't
work. Playing around, I found that the problem somehow involved merged cells.
There were times when I couldn't access the cells and other times when the
TAB key was pressed, it skipped over merged cells. So, I un-merged the cells,
set the locked property to off on all the cells, merged them again and and
the problem was solved.

Hope this might help someone else.
 

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.

Ask a Question

Top