R
RobertK
I was attempting to set up phone numbers in a Contacts Table using the input
mask lookup wizard. Everything seemed to go find; it recommended the
following values for the input mask: !(999) 000-0000 and I chose # as a
placeholder and went on to Finish. The input mask was then displayed as
follows: !(999) 000-0000;0;#
I then went to dataview, and under the Work Phone label it will NOT show the
input mask; it is as if nothing happened. I am using Office XP, a 2002
version of Access.
I would appreciate any help you might give me.
RobertK
mask lookup wizard. Everything seemed to go find; it recommended the
following values for the input mask: !(999) 000-0000 and I chose # as a
placeholder and went on to Finish. The input mask was then displayed as
follows: !(999) 000-0000;0;#
I then went to dataview, and under the Work Phone label it will NOT show the
input mask; it is as if nothing happened. I am using Office XP, a 2002
version of Access.
I would appreciate any help you might give me.
RobertK