B
big thunder
I have three sets of data, two of which are being plotted just fine on the xy
scatter graph. The one set, however, won't start at my x value of 0. The y
values are working fine. X values go up in increments of 0, 0.5, 1, 1.5 etc
all the way up to 12 minutes, but with no 11.5 minute data, so rows 1-24.
Between the six and six and a half minute mark, the graph goes hay-wire and
shifts away from it's zero start point. I check x1, y1 on my graph and it is
actually using x3 with y1. If this makes any sense to anybody please help.
thanks.
scatter graph. The one set, however, won't start at my x value of 0. The y
values are working fine. X values go up in increments of 0, 0.5, 1, 1.5 etc
all the way up to 12 minutes, but with no 11.5 minute data, so rows 1-24.
Between the six and six and a half minute mark, the graph goes hay-wire and
shifts away from it's zero start point. I check x1, y1 on my graph and it is
actually using x3 with y1. If this makes any sense to anybody please help.
thanks.