L
limejello
I am trying to make a template to paint some flames on a wall. I used Visio
to create an outline of flames by tracing an existing bitmap using the
freeform tool. Then I copied the flames and pasted it into the same image so
it will be wide enough to span the whole wall. Then I drew lines from the
ends of the flames; down, across, and up; to represent to bottom of the wall.
My plan was to draw a box to represent the entire wall and overlay the flames
on top. Than way I can mess around with different color schemes. The problem
I have is the flame is not a closed shape, so it won't fill in. The spot
where the original flame connects with the copied flame is not connected.
Each flame has it's own endpoint that I can move indendentaly of each other.
How do I connect these pieces together so I can fill in the flames?
to create an outline of flames by tracing an existing bitmap using the
freeform tool. Then I copied the flames and pasted it into the same image so
it will be wide enough to span the whole wall. Then I drew lines from the
ends of the flames; down, across, and up; to represent to bottom of the wall.
My plan was to draw a box to represent the entire wall and overlay the flames
on top. Than way I can mess around with different color schemes. The problem
I have is the flame is not a closed shape, so it won't fill in. The spot
where the original flame connects with the copied flame is not connected.
Each flame has it's own endpoint that I can move indendentaly of each other.
How do I connect these pieces together so I can fill in the flames?