Connector overlap problem...

[tonyz.wrightz]

Hi,

I am using dynamic glue to attach rectangles using dynamic connectors.
I have (finally) managed to get the dynamic connectors to route around
any shapes that were in the middle. Now my problem is overlapping
connectors.

Looking at the settings, I would have expected the overlapping
connectors to separate by the distance shown in File->Page
Setup->Layout and Routing->Spacing. This is not the case, however. How
do I get the connectors to separate from each other?


Tony

 

[Chris Roth [ Visio MVP ]]

There are more settings in Page > Setup > Layout tab.

You can specify to "separate all lines" and "group together no lines" (yes,
sounds redundant.) It doesn't always work 100%, but it should get you
closer.

--

Hope this helps,

Chris Roth
Visio MVP