J
John
Using Visio 2007 sp1
I have a very large drawing using boxes with connector points three to a
side (all connections going to either the right or left side). I am using
the connector tool to connect the boxes. There are 100s of connectors
running between dozens of these boxes. When I was nearing the end of the
drawing, I no longer got the small red box around a connection point to glue
a connector on the side of the box. It allows a new connector on the top or
bottom of the box, but not on the side. Some boxes with only one connection
point aren;t working at all. If I delete some boxes, it works again but only
for the number of connectors I deleted.
If I take a "broken" box and copy it into a new drawing, it works fine.
Does Visio have a limitation of connectors that can be used in a drawing??!
I have a very large drawing using boxes with connector points three to a
side (all connections going to either the right or left side). I am using
the connector tool to connect the boxes. There are 100s of connectors
running between dozens of these boxes. When I was nearing the end of the
drawing, I no longer got the small red box around a connection point to glue
a connector on the side of the box. It allows a new connector on the top or
bottom of the box, but not on the side. Some boxes with only one connection
point aren;t working at all. If I delete some boxes, it works again but only
for the number of connectors I deleted.
If I take a "broken" box and copy it into a new drawing, it works fine.
Does Visio have a limitation of connectors that can be used in a drawing??!