Connector tool - Dynamic Connector

[Amoni]

Hi again!

The problem is that I need to draw two lines with Visual basic in Visio
without crossing each other. This is to be used in a wiring diagram. I have
tried to use dynamic connector and it does those jumps but I dont know how to
set the position, length, begin- and endpoints.

Ps: I´ve looked at the link that I got from u Al, but that was not really
the problem. Thank u anyway.

 

[David Parker [Visio MVP]]

I didn't see Al's reply, but can we assume that your lines are connected
from one 2D shape to another?
If so, then, if you are using a dynamic connector and dynamic glue, and you
have the right behaviour for your 2D shapes (layout & route around), and you
have got your page layout settings correct ... then Visio will ensure that
the lines are never coincident, and will sort out the jumps for you.