G
Geoff
I use several cmdboxes from the Control Toolbox on a wsheet and each has an
Accelerator. They are laid out in 2 colums and 3 rows.
I've noticed that in design mode if I simply reposition a control its
accelerator underscore sometimes disappears and the only way to make this
visible again is to adjust the control height.
I am sure the height of each control is sufficient for the font size.
Curiously if I increase the control height then the underscore again
disappears.
The only way I can ensure the underscore remains visible in all cases is to
set a different height to the controls instead of all the same.
Can anyone throw any light on this and how can it be prevented?
T.I.A.
Geoff
Accelerator. They are laid out in 2 colums and 3 rows.
I've noticed that in design mode if I simply reposition a control its
accelerator underscore sometimes disappears and the only way to make this
visible again is to adjust the control height.
I am sure the height of each control is sufficient for the font size.
Curiously if I increase the control height then the underscore again
disappears.
The only way I can ensure the underscore remains visible in all cases is to
set a different height to the controls instead of all the same.
Can anyone throw any light on this and how can it be prevented?
T.I.A.
Geoff