Controlling connectors on cross-overs (intersections)

[Mike McCarty]

When two connector lines intersect, one of them will have a break or won't
have a break depending on the behavior settings for those lines. How does
one make one line jump over the other line with a half circle (standard
pipeline nomenclature for cross-overs)? Also, is it possible to have regular
lines behave this was too, or only connector type lines?

Thanks, Mike

 

[AlEdlund]

The ability to control the 'lines' is limited to connectors. To change how
the route go to page setup, select layout and routing and adjust line jumps.
al

 

[Doug.S]

You can do so manually with regular lines by using a half circle jump
shape....locate it where you want it and then connect lines to it. Changes
may require manual adjustments but it does work well.

Doug.S