S
seeker
I have a form that prints checks from a epson lq-570 dot matrix printer.
When an old dos clarion program is used the checks print and stop at tear off
ready for next check to be printed. Under Access the printer prints all that
it needs to on the check but continues moving and does not stop at tear off.
The check size is 8.5" from left to right edge to edge and 7" from top edge
to bottom edge. I have tried margins at 0 for bottom and .25 at top without
any success. I do not see that the form page setup has a custom size to it.
Thank you for your suggestions.
When an old dos clarion program is used the checks print and stop at tear off
ready for next check to be printed. Under Access the printer prints all that
it needs to on the check but continues moving and does not stop at tear off.
The check size is 8.5" from left to right edge to edge and 7" from top edge
to bottom edge. I have tried margins at 0 for bottom and .25 at top without
any success. I do not see that the form page setup has a custom size to it.
Thank you for your suggestions.