C
Cindy
Hi all - this has been bugging me for a few days.
I have created two new Custom Property Sets - one containing power
information (voltage, faceplate finish, # gang switches) and a second one
which contain cost/pricing information.
I select the layer I want to assign the properties, in my case the
electrical fixtures layer.
I APPLY the two new sets to the selected objects.
All looks ok so I enter some data.
I save my document.
I re-open my document.
Only some of the data has been saved, and there is no discernable pattern as
to what is/isn't saved.
Combine this with the fact that sometimes the custom properties window does
not show my new Custom Property Sets, unless I go into the set, open it up,
then simply click OK, and the custom properties window is then refreshed.
Installation is Visio 2003 Standard SR2.
Thanks in advance, Cindy
APOLOGIES for the cross-post to trobuleshooting
I have created two new Custom Property Sets - one containing power
information (voltage, faceplate finish, # gang switches) and a second one
which contain cost/pricing information.
I select the layer I want to assign the properties, in my case the
electrical fixtures layer.
I APPLY the two new sets to the selected objects.
All looks ok so I enter some data.
I save my document.
I re-open my document.
Only some of the data has been saved, and there is no discernable pattern as
to what is/isn't saved.
Combine this with the fact that sometimes the custom properties window does
not show my new Custom Property Sets, unless I go into the set, open it up,
then simply click OK, and the custom properties window is then refreshed.
Installation is Visio 2003 Standard SR2.
Thanks in advance, Cindy
APOLOGIES for the cross-post to trobuleshooting