D
David
Greetings all,
I was wondering if there is a way to programmatically
manupulate the Default database folder located under
Tools - Option general tab.
Specificaly what I am attempting is to open an old Foxpro
database located on a shared drive. I am able to do this
within a Shell, but little did I know that Foxpro uses all
these supporting files that are located in the same
place/folder on the shared drive.
Somewhere along the line the Default database location is
getting in the way because Foxpro starts to look there for
its supporting files.
Maybe I am looking at this wrong and all I need to do is
change the current path?
Any help and or suggestions would be great!
Thanks all,
David
I was wondering if there is a way to programmatically
manupulate the Default database folder located under
Tools - Option general tab.
Specificaly what I am attempting is to open an old Foxpro
database located on a shared drive. I am able to do this
within a Shell, but little did I know that Foxpro uses all
these supporting files that are located in the same
place/folder on the shared drive.
Somewhere along the line the Default database location is
getting in the way because Foxpro starts to look there for
its supporting files.
Maybe I am looking at this wrong and all I need to do is
change the current path?
Any help and or suggestions would be great!
Thanks all,
David