drawing electronic connections using modern standards

[eganders]

Is there any EASY way to show a schematic with a wire connecting with a
dot and not connecting by just passing over the wire?

I have used Visio for drawing schematics many times in the past. I
have always been frustrated with the Visio way of drawing single wire
connections. The convention Visio uses is like the old schematics from
the middle of the 20th century. That is, all wires NOT connected are
shown with the wire jumping (bridging/hopping) over the wire. A
connection is shown when the wire crosses straight over the wire. Is
there any EASY way to show a schematic with a wire connecting with a
dot and not connecting by just passing over the wire as a real modern
schematic is generated? I once "created" a dot to put on a connected
intersection, but I felt that it complicated my effort.

 

[JuneTheSecond]

You might make macro to put a dot on the intersection of two conectors.
You might run macro and select two connectors.
If you wish more automatic way, you should find a way for Visio let to know
whether two conectors are conecting or just passing.