N
Neil
I am trying to split a connector into 2 connectors by placing an object in
between them. I have set the page level and application level properties to
allow splitting, and I've allowed split/splitting on the objects I'm using.
It will only allow me to split a connector if it is not near any other
objects, and sometimes it will only let me split a section of the connector.
Is there a setting I am missing? I'm using visio 2003.
Thank you,
Neil
between them. I have set the page level and application level properties to
allow splitting, and I've allowed split/splitting on the objects I'm using.
It will only allow me to split a connector if it is not near any other
objects, and sometimes it will only let me split a section of the connector.
Is there a setting I am missing? I'm using visio 2003.
Thank you,
Neil