M
Mac
Is there a way to get around this error in Visio 2003?
J
JuneTheSecond
Did you see this?
http://www.mcse.ms/message961624.html
http://www.mcse.ms/message961624.html
J
JuneTheSecond
I am sorry. This was not suitable example.
In my simple test, I could not insert a control on the page that is crowded
with shapes, so inserted a control on a new blank page and copy the crowded
page here, this is done well.
In my simple test, I could not insert a control on the page that is crowded
with shapes, so inserted a control on a new blank page and copy the crowded
page here, this is done well.
M
Mac
Yep, I had read that discussion before I decided to post here...I found no
reasonable solution there, though.
Your next post is a solution I might consider, thanks Yoda!
I have slightly over 1000 shapes on a page and thousands of layers, so I'd
better think twice before moving all this to a new page. I had resolved to
insert two buttons to be used for launching some code over all these shapes
(which triggered that 1441 horror message...); but then I realized that I can
run my routines as simple macros, so I do not need them buttons...yet.
Thank you fo reply, anyway!
reasonable solution there, though.
Your next post is a solution I might consider, thanks Yoda!
I have slightly over 1000 shapes on a page and thousands of layers, so I'd
better think twice before moving all this to a new page. I had resolved to
insert two buttons to be used for launching some code over all these shapes
(which triggered that 1441 horror message...); but then I realized that I can
run my routines as simple macros, so I do not need them buttons...yet.
Thank you fo reply, anyway!