Errors after Modifying Access 2000 db using Access 2003

[kosakahonmachi]

I know this proplem has been posted and several solutions have been posted,
but I cannot get any of them to work, and I'm at wits end. Someone in the
company developed a db in Access 2000 that is extremely useful, but after
years of using, I've thought of a few ways to improve upon it (via Access
2003).

I was finally able to update the Forms, Macros, and Modules, and get the db
working as I wanted. However, after I closed the db and re-opened it for its
final testing, I got the dreaded "Module Not Found" error when I clicked on
one of the command buttons.

I feel like I have tried all of the solutions posted (rebuild after first
deselecting Name Autocorrect, Decompling, etc), but I cannot get it to work.
What is REALLY strange is that it doesn't happen after a Save, only after a
Close and re-Open. Also, I've had it work after closing it one or two times,
but then fail on the third or fourth attempt.

Can anyone make sense of this and point me in the right direction? I would
really appreciate it, as I've invested quite a bit of time in this (and it's
not really my responsibility, but we don't have anyone else who would do it).

Thanks in advance

 

[Tom van Stiphout]

On Tue, 11 Dec 2007 05:44:00 -0800, kosakahonmachi

Perhaps you could install Office 2003 SP3 and try again.
-Tom.

 

[kosakahonmachi]

I'm sorry I forgot to mention in my original post that I installed Office SP3
as my first attempt to correct the problem (to no avail). Thanks, though!