S
Simon
I need help...all of a sudden, my database has changed how
it performs the "find" comand. It used to look for a
value, starting on the current record, going to the final
record, and then continue from the first record, and stop
when it got back to the original record, until it found
the value I was looking for. Now, it will only go as far
as the last record in the database, and not go back to the
first record to continue searching.
Here's the problem...I have not changed any settings to
make it do this. I'm assuming the "Search" option in
the "Find" window would control this, by switching it
from "All" to "Up" or "Down", but I have not changed
this. Even if it is still set to "All", it stops at the
last record, and does not go back to the first record to
continue the search.
Any insight?
it performs the "find" comand. It used to look for a
value, starting on the current record, going to the final
record, and then continue from the first record, and stop
when it got back to the original record, until it found
the value I was looking for. Now, it will only go as far
as the last record in the database, and not go back to the
first record to continue searching.
Here's the problem...I have not changed any settings to
make it do this. I'm assuming the "Search" option in
the "Find" window would control this, by switching it
from "All" to "Up" or "Down", but I have not changed
this. Even if it is still set to "All", it stops at the
last record, and does not go back to the first record to
continue the search.
Any insight?