Form Control Wizrds not starting

[Jim McColl]

I recently upgraded from Office 2000 to 2003 and have had no problems until
today.

All of a sudden when I try to create a command button or combo box on a
form, the wizard doesn't start.

I have seen suggestions to press in the wand icon on the tool bar. However,
when I hover over this bar it says "Build" and if I clcik on it I get a
dialogue box asking me to choose a builder. I am running in sandbox mode
and have the latest Jet engine installed.

Not only that, I have built combo boxes and command buttons with the wizard
just fine up until today.

Regards & Thanks for any help

 

[fredg]

I recently upgraded from Office 2000 to 2003 and have had no problems until
today.

All of a sudden when I try to create a command button or combo box on a
form, the wizard doesn't start.

I have seen suggestions to press in the wand icon on the tool bar. However,
when I hover over this bar it says "Build" and if I clcik on it I get a
dialogue box asking me to choose a builder. I am running in sandbox mode
and have the latest Jet engine installed.

Not only that, I have built combo boxes and command buttons with the wizard
just fine up until today.

Regards & Thanks for any help

PerhapsI miss-understand what you mean by
'the wand icon on the tool bar'.
It's the wand button located within the tool box (the Hammer and
Wrench icon) that you have to depress. Then drag the command button
onto your form and the wizard should start.

 

[Jim McColl]

That did the trick - Makes me feel kind of stupid. Thanks very much for a
very prompt and helpful response.

Regards