FORMS HELP NEEDED part 2

[Groovespacecadet]

Is is possible to define, in the tab area -- a different configuration of
columns? I've noticed that the Tab group can only do one column. If I
select a field in my tab group, my options are only to move up or down...and
that I can't have..say a 3 column form, and a two column tab...is this
possible?

 

[Frances Selkirk [MSFT]]

Assuming Groove 2007, you can do this. Look above the Preview on the right
side of the Designer. You should see a box labeled "No Tab Selected". Select
the tab group. This will change the title to the Tab name and enable the
column selection control.

I hope this helps!

 

[Groovespacecadet]

Thanks. Would you have any idea why, when I select the tab group (by
clicking on it in the preview) my "No Tab Selected" option is greyed-out?

 

[Frances Selkirk [MSFT]]

It worked for me. I did, however, find it difficult to select the tab group
rather than one of its components. I had to click around a lot.

Okay -- after experimenting for a few minutes, I think I've got it. To
select the tab group, you need to click at the right edge of it, rather than
at the left, where the label will be by default. In other places, the
mouse-over text will say you can select it by clicking, but you can't.


--
Frances Selkirk [MSFT]
Disclaimer: This posting is provided "AS IS" with no warranties, and confers
no rights.

 

[Groovespacecadet]

Thanks! this helped. I also was not using a tab label, which made it even
more difficult to select.