J
Jeff Hunt
I have several workbooks that contain Aut
pen macros. All were originally
written on a 2003 installation. Now that my primary machine has 2007 on it,
I find that I cannot prevent the Autpen macro from running by holding the
shift key down when opening the files. I know in 2003 if you set the macro
security level to low the shift key stops working. However, I’ve tried
changing several settings in the Trust Center (such as trusting the files’
location) but to no avail. I also know that if I leave the location
untrusted it will allow me to not run the macro, but if I then try to test
the Autpen macro (or any other macro for that matter) manually during that
session it fails because it says I disabled the macros. Moving the files
back to a 2003 installation resumes the expected hold-shift-to-stop
functionality. Is this feature no longer available in 2007 or am I just
missing something?
pen macros. All were originallywritten on a 2003 installation. Now that my primary machine has 2007 on it,
I find that I cannot prevent the Aut
pen macro from running by holding theshift key down when opening the files. I know in 2003 if you set the macro
security level to low the shift key stops working. However, I’ve tried
changing several settings in the Trust Center (such as trusting the files’
location) but to no avail. I also know that if I leave the location
untrusted it will allow me to not run the macro, but if I then try to test
the Aut
pen macro (or any other macro for that matter) manually during thatsession it fails because it says I disabled the macros. Moving the files
back to a 2003 installation resumes the expected hold-shift-to-stop
functionality. Is this feature no longer available in 2007 or am I just
missing something?