M
Mark
Hi All,
I have seen posts which touch on the subject but have not found a solution as of yet.
Hopefully I can explain this OK.....What I am trying to do is
create a QC check sheet using the following fields: ASN, PO & Qty. This
information will be at the top of each report with loads of labels
below which users will have as a check list.
1 ASN may have many PO's and the Qty is at PO level so 1 Qty for each PO
I have set it up so far so that a new page is forced for each ASN. On
each page there should be 1 ASN number, however many PO's that belong to
each ASN and the Qty of units for each PO.
The problem I am having is that I can't work out how to get a list of
PO's (horizontal) across the top. If I put the PO in the header, only
the first one will appear. If I put it in the detail section, the list
is vertical and goes down the page rather than across it which wont work for
this report.
I have seen in other posts people saying to "make sure the field is set to horizontal". How do you do this?
Any help on this would be magic as I have wasted days trying to figure it out.
TIA
I have seen posts which touch on the subject but have not found a solution as of yet.
Hopefully I can explain this OK.....What I am trying to do is
create a QC check sheet using the following fields: ASN, PO & Qty. This
information will be at the top of each report with loads of labels
below which users will have as a check list.
1 ASN may have many PO's and the Qty is at PO level so 1 Qty for each PO
I have set it up so far so that a new page is forced for each ASN. On
each page there should be 1 ASN number, however many PO's that belong to
each ASN and the Qty of units for each PO.
The problem I am having is that I can't work out how to get a list of
PO's (horizontal) across the top. If I put the PO in the header, only
the first one will appear. If I put it in the detail section, the list
is vertical and goes down the page rather than across it which wont work for
this report.
I have seen in other posts people saying to "make sure the field is set to horizontal". How do you do this?
Any help on this would be magic as I have wasted days trying to figure it out.
TIA