A
Andreas
Motion of a crane with three beams, interconnected by two pin-joints is
limited by one end's fixed position, the length of the three beams and the
angle of the two joints. I'd like to demonstrate motion and the envelope
limits of that crane by draging the outer end of the crane.
Is this possible in Visio2003 by using standard shaps?
limited by one end's fixed position, the length of the three beams and the
angle of the two joints. I'd like to demonstrate motion and the envelope
limits of that crane by draging the outer end of the crane.
Is this possible in Visio2003 by using standard shaps?