How can I Edit a Master shape in Visio

S

shailendrasingh823

Hi All,


How can i edit a already exsisting Master Shape,for example I have
Ethernet Master shape,which has 3 ports on one sode & 2 ports on other
side. I want to add one more on the side which have 2 ports.

Regards
Shail
 
J

JuneTheSecond

Easy way might be to drop the mastershape on your drawing, edit and drag and
drop on your new stencil, and then save in your personal folder.
 
J

John Marshall, MVP

If you look at the ethernet shape while selected, you will see yellow
diamonds (control handles) that will let you move end points of the lines.
You will also notice two more diamonds on the enter line of the shape at the
1/3 and 2/3 point. You can drag these control handles to the top or bottom
to add more lines. Actually, there are more than two control handles on the
center line. It is just that they are stacked. In Visio 2007, there are 64
control handles.

In the old days there was about ten control handles and the "trick" to get
more was to drop a second shape on top of the first. Visually it looked
correct, but any program interrogating the diagram would see two ethernet
shapes. So depending on your use, the trick may have been useful. As with
all Visio shape, it is possible to add extra lines to the shape, but it does
take time.

John... Visio MVP

Need stencils or ideas? http://visio.mvps.org/3rdparty.htm
Need VBA examples? http://visio.mvps.org/VBA.htm
Visio Wishlist http://visio.mvps.org/wish_list.htm
 

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.

Ask a Question

Top