How do I keep the Header , Detail and Footer on the same page?

[ZBC]

I have a report that is grouped on 'Category'.
The report works fine, however, I would like to keep the 'Category'
Header, Detail and Footer together if possible.
If they cannot all three be placed on the current page, then I would
like to start a new page.
Each category is generally less than a 1/3 page.
Am I asking too much?

 

[Rod]

Try setting the footer to force a new page after or
setting the header to force a new page before a change in
category. You might end up with a blank page occasionally
but this should be rare.

 

[Marshall Barton]

I have a report that is grouped on 'Category'.
The report works fine, however, I would like to keep the 'Category'
Header, Detail and Footer together if possible.
If they cannot all three be placed on the current page, then I would
like to start a new page.
Each category is generally less than a 1/3 page.
Am I asking too much?

No, you're not asking too much. Just set KeepTogether
property of the category **group** to Entire Group (in
sSorting and Grouping window). Note that this is not the
KeepTogether property that can be set for individual
sections.

 

[ZBC]

Thank You!

ZBC wrote:




No, you're not asking too much. Just set KeepTogether
property of the category **group** to Entire Group (in
sSorting and Grouping window). Note that this is not the
KeepTogether property that can be set for individual
sections.