X
xppuser
hi all,
wxp pro sp2, office 2003 sp2,
i am using Insert -> Cross-reference function, which brought up the
Cross-reference dialog box (the one where it asks for Reference type:, Insert
reference to:, and For which caption:, and etc). is there a way to enlarge
or at least widen the width of this (Cross-reference) dialog box? maybe there
is a key somewhere in the registry to this dialog box behaviour
e.g. setting the size of the dialog box. the reason i ask is because
sometimes i am not unable to choose the caption without reading almost the
entire caption. this would then necessitate me of having to go where the
figure is (are), remember it (them) then going to back to the text to enter
the Cross-reference.
i am displaying Only label and number (i.e. Figure x) and i know one work
around would be to choose to display the whole caption initially (to check)
then delete them and re-insert the caption as only label and number but this
would be counter-productive (but maybe necessary!).
thank you for your advice/help,
jes
ps: i have floated this question over at the office newsgroup but a single
response thus far suggests that it is not do able. however my understanding
is that the registry controls the behaviour of all manners of software
set-up, including in my case, the Cross-reference dialog box size. i just
don't know where this is situated and which value(s) to change to what, if
there was one to begin with.
wxp pro sp2, office 2003 sp2,
i am using Insert -> Cross-reference function, which brought up the
Cross-reference dialog box (the one where it asks for Reference type:, Insert
reference to:, and For which caption:, and etc). is there a way to enlarge
or at least widen the width of this (Cross-reference) dialog box? maybe there
is a key somewhere in the registry to this dialog box behaviour
e.g. setting the size of the dialog box. the reason i ask is because
sometimes i am not unable to choose the caption without reading almost the
entire caption. this would then necessitate me of having to go where the
figure is (are), remember it (them) then going to back to the text to enter
the Cross-reference.
i am displaying Only label and number (i.e. Figure x) and i know one work
around would be to choose to display the whole caption initially (to check)
then delete them and re-insert the caption as only label and number but this
would be counter-productive (but maybe necessary!).
thank you for your advice/help,
jes
ps: i have floated this question over at the office newsgroup but a single
response thus far suggests that it is not do able. however my understanding
is that the registry controls the behaviour of all manners of software
set-up, including in my case, the Cross-reference dialog box size. i just
don't know where this is situated and which value(s) to change to what, if
there was one to begin with.