G
G Lykos
Greetings! This is to ask what needs to be done so that the Group command
stops changing connector routings which I've manually modified back to the
automatic routes. This happens to be Visio 5, but I have Visio 2K available
if helpful.
The reason for doing this is that I'm selecting the entire drawing and then
rotating it 180 degrees to feed it right-edge first into a DeskJet printer
so that I don't loose the right edge at 1/4" margin setting since the
left-edge margin is wider to allow for hole punches. I'm open to
alternative approaches.
Thanks!
George Lykos
(e-mail address removed)
stops changing connector routings which I've manually modified back to the
automatic routes. This happens to be Visio 5, but I have Visio 2K available
if helpful.
The reason for doing this is that I'm selecting the entire drawing and then
rotating it 180 degrees to feed it right-edge first into a DeskJet printer
so that I don't loose the right edge at 1/4" margin setting since the
left-edge margin is wider to allow for hole punches. I'm open to
alternative approaches.
Thanks!
George Lykos
(e-mail address removed)