Howto recover corrupt Access reports

[Seatech]

Hello.
I had a working Access DB with a lot of reports. Then I installed
another printer and made the old one standard again. After that I can't
open any of my reports. Not even in design mode. Anybody have a tip on
how to recover this? I tried to export all my reports to another mdb
file, but it's the same error. The error message says something about
problems getting the right printer info.

 

[Al Campagna]

Seatech,
This problem is due to an improperly installed/configured Windows default printer. The
reports, in preview or design mode, use the printer definitions/drivers to display the
objects, and without a default printer it is unable to do that.
Try deleting your default printer, reinstall the driver, and then make that printer the
Default again. This is more of a Windows problem than an Access problem, so perhaps
someone on a Windows newsgroup might have some suggestions if the above doesn't work.

 

[Seatech]

Thank You very much.
Best regards,

Lars Jensen.

Al Campagna skrev: