InfoPath 2007 Scrolling Region issue

[Smolakm]

I am working with Infopath 2007 beta2 and am setting up my first form. I
created a Scrolling Region and placed a layout table within it. I set the
scrolling section to Always show vertical Scroll bar. Problem is that the
scoll controls do not show up in design or preview mode. So when the info
in the layout table goes below the scrolling region window size, you cannot
get to the info at the bottom. Has anyone else run into this, and if so,
how did you get around it?
Thanks.

 

[Kalyan Reddy]

Hi

I did exactly the same steps as you mentioned and I very well can see the
scrolling section and also the information beyond the Scrolling Window.
May be you should play around with the Size(Ht and Width) of the Scrolling
window to understand why you aren't seeing the scrolling region.

 

[Smolakm]

I did finally resolve this. I had played around with the Ht and Wd settings
to no avail. What was happening was that I added the Scrolling Region within
a cell of a layout table. Because I was lining all the cells in the layout
table out evenly, the scroll control was being rendered behind the right edge
of the cell it was in. I ended up moving the region outside of the confinds
of the layout table and it is functioning fine. Thanks.