L
LovinLife
Hi all-- i could really use another set of eyes or expertise. To do a custom
install of Project 2003 I have edited the setup.ini & created a transform.
Everything installs great on the pc i created it on but getting this error
msg on other pc's: Verify that the specified transform paths are valid. I
checked to make sure i don't have an absolute path in either the ini file or
the mst... i have done internet searches,etc, etc I am to the point of
pulling my hair out! I even opened up the MSI just to verify that nothing
was altered when i created the mst file using Installshield. Any
ideas/solutions would be welcome!
install of Project 2003 I have edited the setup.ini & created a transform.
Everything installs great on the pc i created it on but getting this error
msg on other pc's: Verify that the specified transform paths are valid. I
checked to make sure i don't have an absolute path in either the ini file or
the mst... i have done internet searches,etc, etc I am to the point of
pulling my hair out! I even opened up the MSI just to verify that nothing
was altered when i created the mst file using Installshield. Any
ideas/solutions would be welcome!