K
kandi
I know this has probably been dealt with here but I am
going through major frustration. I am setting up a table
with 5 columns and about 25 rows. Margins are pretty
small and it is being done in landscape mode. Since it is
a mailing list of sorts there are about three or four
lines of text in each row. In setting it up the first
time I just set up a table with about two rows and kept
it going until I was done. However, after the third row
it inserted a page preak way too soon. I checked
everything and nothing fixed it. Then I set up a new
table in a new document with the exact number (I thought)
of rows I needed. All was fine until I needed to add a
row which was towards the end of the table. As soon as I
add the row the page break appears after the third row. I
have gone to the knowlege base and done everything it
says to do. Nothing whatsoever is helping. Does anyone
out there have any suggestions as to why this is
happening and what I can do to fix it? My greatest
appreciation to all...
going through major frustration. I am setting up a table
with 5 columns and about 25 rows. Margins are pretty
small and it is being done in landscape mode. Since it is
a mailing list of sorts there are about three or four
lines of text in each row. In setting it up the first
time I just set up a table with about two rows and kept
it going until I was done. However, after the third row
it inserted a page preak way too soon. I checked
everything and nothing fixed it. Then I set up a new
table in a new document with the exact number (I thought)
of rows I needed. All was fine until I needed to add a
row which was towards the end of the table. As soon as I
add the row the page break appears after the third row. I
have gone to the knowlege base and done everything it
says to do. Nothing whatsoever is helping. Does anyone
out there have any suggestions as to why this is
happening and what I can do to fix it? My greatest
appreciation to all...