Line jumps on curved connectors?

A

agbvisio

I've been struggling with getting line connectore to work. I just realized
that they don't seem to work with curved connectors. If I change back to a
right angle connector and move the connector slightly the line jumps show up.
But never for curved connectore, even if the PAge Setup-->LAyout and
RTouting --? appearance is set to curved.

Any clues?
 
P

Paul Herber

I've been struggling with getting line connectore to work. I just realized
that they don't seem to work with curved connectors. If I change back to a
right angle connector and move the connector slightly the line jumps show up.
But never for curved connectore, even if the PAge Setup-->LAyout and
RTouting --? appearance is set to curved.

You are right, line jumps don't work on curved connectors. I don't think there is any way
round this.
 

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.

Ask a Question

Top