J
JeffH
I have a macro that accesses some Access queries and refreshes information in
my Excel worksheet. The queries work and the data properly refreshes the
data in my workbook. I wanted to then have the macro paste some of the
information in certain cells.
I created a macro (Macro2) that grabs the cells and pastes it into the
spreadsheet. This works fine. I created Macro2 so I would not have to
figure out the code and I could just paste it into my original macro.
However, when I take the same code from Macro2 and just append it to the
original macro, the paste does not update the cells. I can see the orginal
macro goes through all the steps (as pasted from Macro2) but the cells don't
get updated.
When I run Macro2 the cells get updated (copied and pasted) from the data I
imported from Access.
I'm stumped, this should work.
my Excel worksheet. The queries work and the data properly refreshes the
data in my workbook. I wanted to then have the macro paste some of the
information in certain cells.
I created a macro (Macro2) that grabs the cells and pastes it into the
spreadsheet. This works fine. I created Macro2 so I would not have to
figure out the code and I could just paste it into my original macro.
However, when I take the same code from Macro2 and just append it to the
original macro, the paste does not update the cells. I can see the orginal
macro goes through all the steps (as pasted from Macro2) but the cells don't
get updated.
When I run Macro2 the cells get updated (copied and pasted) from the data I
imported from Access.
I'm stumped, this should work.