N
Nathan Vanderslice
I am trying to make a form for a medical release form that has a total of 50
fields using Access 2000 With the single table, I have tried to have the
form wizard make the initial form and then edit the layout as I have done
before but the wizard says that there are too many fields. Is this something
that I am stuck with, or will going through and adjusting the field lengths
to what is needed, solve this problem? The next question is that I have
split the table into two parts, but when trying to build a from in design
view I can't seem to bring up a list of fields from either table to bring
into the form. What am I doing wrong? Note: I would rather be able to have
all of the fields in one form rather than trying to work with two forms and
then merging the info into a report
fields using Access 2000 With the single table, I have tried to have the
form wizard make the initial form and then edit the layout as I have done
before but the wizard says that there are too many fields. Is this something
that I am stuck with, or will going through and adjusting the field lengths
to what is needed, solve this problem? The next question is that I have
split the table into two parts, but when trying to build a from in design
view I can't seem to bring up a list of fields from either table to bring
into the form. What am I doing wrong? Note: I would rather be able to have
all of the fields in one form rather than trying to work with two forms and
then merging the info into a report