Manual Calculation

S

Steven

I have a large file File01 that takes about 10 seconds to calculate. It is
sometimes on Automatic Calculation. I have another file File02 that I want
to open and on File02's Auto_Open I set Application.Calculation = xlManual.
But when the file File02 opens the system recalculates when I thought because
I did the Application.Calculation = xlManual that this would stop it and go
immediately to Manual. Basically when I open File02 I want to go to Manual
Calc and do not want File01 to calculate.

Thank you,

Steven
 
T

Tom Ogilvy

No, the code doesn't execute until after the calculation occurs. You would
need a file03 in the auto_open, sets the calculation mode, then opens file02
and closes itself.
 

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.

Ask a Question

Similar Threads

Cannot get message box to show 1
Opening a file from another file 1
Turning off automatic calculation 0
I hope to get many responses on this. 9
Switching to Manual Calculation stalls workbook 1
Auto Calculate selected worksheets 5
Combo box source from other workbook 1
event handler for calculation 4

Top