J
John
Hi,
I'm just trying to connect up some rectangle shapes using the dynamic
connector in a hierachical left to right format (ie parent to children).
All works ok apart from the connectors, which I want to start from the same
point (the right hand side of the parent shape). Instead they are
distributed around the shape.
I've set the routing style in page setup to left-right and overlap on lines
etc but no joy.
Do I need to do something to the shape's shapesheet connections section?
I've tried changing the inward/outward types, but I get a little confused as
to what these do (plus they don't seem to have any effect, on my particular
problem at at least).
Anyway, I sure this is a regular question (I have looked through the
newsgroup already!).
Thanks
John
I'm just trying to connect up some rectangle shapes using the dynamic
connector in a hierachical left to right format (ie parent to children).
All works ok apart from the connectors, which I want to start from the same
point (the right hand side of the parent shape). Instead they are
distributed around the shape.
I've set the routing style in page setup to left-right and overlap on lines
etc but no joy.
Do I need to do something to the shape's shapesheet connections section?
I've tried changing the inward/outward types, but I get a little confused as
to what these do (plus they don't seem to have any effect, on my particular
problem at at least).
Anyway, I sure this is a regular question (I have looked through the
newsgroup already!).
Thanks
John