J
Jeff
I have a database that currently has one linked Oracle
table through an ODBC connection. When I view the table in
datasheet mode or run a query to look at data, upon
closing of the table or query I receive the following
error: "This action will reset the current code in break
mode". The only way to get out of the Table or Query is to
go into the design mode and close it. I know this problem
occurs when a database has been idle for sometime, but
this is happening even if I open the table for only a few
seconds and then try to close it. Does anyone know if
there is a setting in oracle or in Access to handle this?
Thanks
table through an ODBC connection. When I view the table in
datasheet mode or run a query to look at data, upon
closing of the table or query I receive the following
error: "This action will reset the current code in break
mode". The only way to get out of the Table or Query is to
go into the design mode and close it. I know this problem
occurs when a database has been idle for sometime, but
this is happening even if I open the table for only a few
seconds and then try to close it. Does anyone know if
there is a setting in oracle or in Access to handle this?
Thanks