Only one connection point for switch ?

[Philippe C.]

Reading my third book on Visio, I had another try with my mother of all
problems : how to place a an electrical switch at a distance of a wall.
I found out that the connection point on the opposite side of the tail of
the switch is the lucky one that allwas gets glued. So I flip the shape
before gluing. The other one never gets glued, how much I change its
properties like In DirX/A DirY/B Type/C.
I can place the connection point out of the alignment box.
But whatever I do, like adding a third one, only one connection point gets
glued.

Does anyone have an explanation ?

And of course the switch should flip itself in the right way after gluing.