P
peter
After laying down walls that are orthogonal (either vertical or horizontal)
and snapping them to each other and moving them apart, sometimes I find a
wall that is slightly non orthogonal and slightly longer than its original
length.
E.g. I may have a wall that was 2 ft 3 inches. Sometime later I may find
that it becomes 2 ft 3.01 inches and is slightly off vertical. If I right
click and change the length back to 2 ft 3 inches, it returns to vertical
again.
I don't have the exact repro scenerio. But has anyone else seen this? It has
happened at least twice in the past few days. I would like this to stop.
and snapping them to each other and moving them apart, sometimes I find a
wall that is slightly non orthogonal and slightly longer than its original
length.
E.g. I may have a wall that was 2 ft 3 inches. Sometime later I may find
that it becomes 2 ft 3.01 inches and is slightly off vertical. If I right
click and change the length back to 2 ft 3 inches, it returns to vertical
again.
I don't have the exact repro scenerio. But has anyone else seen this? It has
happened at least twice in the past few days. I would like this to stop.