Page set-up question

[rebecca]

I have 9 figures on 9 separate pages. How do I change just one of the pages
from portrait to landscape. When I tried to change it in Page Set-up, all 9
pages were changes - I don't want that. I just want to change one page from
portrait to landscape. Thank you!!

 

[Al Edlund]

go to page setup and make sure it is not the same as the printer....
al

 

[kpundt]

If you are using Visio 2003, hold your control key down, place your cursor on
the top left corner. The cursor will change into a circle with an arrow.
Drag is down and to the right a bit until it is in landscape position. The
drawing may not go with the change, so you may need to select the whole
drawing (ctrl A) and pivot it around.

Page set up is used to change the entire document, not just one page. FYI