part of my publisher document is missing when i print

[Chris Catling]

I am printing a document on oversized paper - when viewed in print preview
all is fine, I have checked the page layout and set-up and this is all
correct. However when the document is sent to the printer the last 5% of the
document is missing. The help section suggests changing the printer memory
but this does not seem to alter anything. The last 5% of the document is also
missing even if I decrease the size of the document.

 

[JoAnn Paules [MSFT MVP]]

What do you consider oversized?

 

[Mary Sauer]

Have you checked to see if you have the most current driver for your printer?
Publisher is more critical about drivers than most applications.
Go to the manufacturer's web site and look around.

 

[Chris Catling]

900x300mm
--
Chris Catling

What do you consider oversized?

--

JoAnn Paules
MVP Microsoft [Publisher]

I am printing a document on oversized paper - when viewed in print preview
all is fine, I have checked the page layout and set-up and this is all
correct. However when the document is sent to the printer the last 5% of
the
document is missing. The help section suggests changing the printer memory
but this does not seem to alter anything. The last 5% of the document is
also
missing even if I decrease the size of the document.

 

[Mary Sauer]

What are your margin limitations?
What version Publisher? Have you considered creating a PDF and printing from it? Free
conversion here:
http://www.primopdf.com/

Might read this, you may not have the Design Jet but it does address large size
printing.

PUB2000: Large Banners and Posters Are Printed in Separate Sections on a Hewlett
Packard DesignJet Plotter
http://support.microsoft.com/default.aspx?scid=kb;en-us;244321

--
Mary Sauer MSFT MVP
http://office.microsoft.com/

900x300mm
--
Chris Catling

What do you consider oversized?

--

JoAnn Paules
MVP Microsoft [Publisher]

I am printing a document on oversized paper - when viewed in print preview
all is fine, I have checked the page layout and set-up and this is all
correct. However when the document is sent to the printer the last 5% of
the
document is missing. The help section suggests changing the printer memory
but this does not seem to alter anything. The last 5% of the document is
also
missing even if I decrease the size of the document.