M
Mike
Hi,
I use a form to select a range of dates for my report. The latter is drawing
the data from a stored procedure and all works fine. In a field, I want to
show the range of dates so I use (in the header section) ="Period between"&
[@D_Start] & " and " & [@D_End]. Interestingly [@D_End] it's not shown.
However, if I switch to design and back to view, the date is shown. I
noticed this peculiarity after I upgraded to 2007 from 2003. Any idea where
I should tweak?
TIA
Mike
I use a form to select a range of dates for my report. The latter is drawing
the data from a stored procedure and all works fine. In a field, I want to
show the range of dates so I use (in the header section) ="Period between"&
[@D_Start] & " and " & [@D_End]. Interestingly [@D_End] it's not shown.
However, if I switch to design and back to view, the date is shown. I
noticed this peculiarity after I upgraded to 2007 from 2003. Any idea where
I should tweak?
TIA
Mike