C
Christine
Three problems here:
1) I have Access 2002 SR-1, operating under Windows XP. I
installed the SR-2 pack from the MS website, but the Help
About screen still says the programme is at SR-1. What
could I be doing wrong?
2) In Tools, Options, I want to specify measurements (for
print margins, for example) in inches - not centimeters.
Windows Control Panel doesn't allow you to specify these
kinds of measurement units. How do I set it to my
preference?
3)In Tools, Options, Datasheet tab, the list of fonts is
empty. At any rate, I specify that I want the default font
size to 12 points, but the programme still insists on
creating new forms, etc in 8 point. So, (a) How do you get
the fonts to list in the drop-down box and (b)How do you
get your preferred font size to apply?
Many thanks to anyone who can help.
Christine
1) I have Access 2002 SR-1, operating under Windows XP. I
installed the SR-2 pack from the MS website, but the Help
About screen still says the programme is at SR-1. What
could I be doing wrong?
2) In Tools, Options, I want to specify measurements (for
print margins, for example) in inches - not centimeters.
Windows Control Panel doesn't allow you to specify these
kinds of measurement units. How do I set it to my
preference?
3)In Tools, Options, Datasheet tab, the list of fonts is
empty. At any rate, I specify that I want the default font
size to 12 points, but the programme still insists on
creating new forms, etc in 8 point. So, (a) How do you get
the fonts to list in the drop-down box and (b)How do you
get your preferred font size to apply?
Many thanks to anyone who can help.
Christine