Procedure entry point couldn't be located....

[Bob Fliegel]

I have been using FP2000 for the last couple years. Today
I installed FP2003 Beta, but didn't replace the earlier
version. They are now two separate programs on my hard
drive. I cannot, however, access either of them,
receiving fol error msg: "procedure entry point couldn't
be located in the dynamic link library fpcutl.dll."
Obviously, my installation of 2003 created a path
problem. How can I fix it so that I can access either
version of FP? I did a search for that .dll file and
found that the earlier version is in
c:\ProgramFiles\MicrosoftOffice\Office and the later
version in c:\ProgramFiles\MicrosoftOffice\Office11.

 

[Bob Fliegel]

I suppose I could simply uninstall both versions, then
reinstall only one of them. Would that serve to correct
the .dll path confusion?

 

[Stefan B Rusynko]

Yes

And if you do reinstall the Beta (after you reinstall FP2000) make sure it is a custom install to a different folder than your
FP2000




| I suppose I could simply uninstall both versions, then
| reinstall only one of them. Would that serve to correct
| the .dll path confusion?
|

 

[Brent]

I have been using FP2000 for the last couple years. Today
I installed FP2003 Beta, but didn't replace the earlier
version. They are now two separate programs on my hard
drive. I cannot, however, access either of them,
receiving fol error msg: "procedure entry point couldn't
be located in the dynamic link library fpcutl.dll."
Obviously, my installation of 2003 created a path
problem. How can I fix it so that I can access either
version of FP? I did a search for that .dll file and
found that the earlier version is in
c:\ProgramFiles\MicrosoftOffice\Office and the later
version in c:\ProgramFiles\MicrosoftOffice\Office11.

i have the same prob. fp 2003 will not load...anybody from MS watching????

 

[Stefan B Rusynko]

Explain what you have installed from the BETA CD's




| > I have been using FP2000 for the last couple years. Today
| > I installed FP2003 Beta, but didn't replace the earlier
| > version. They are now two separate programs on my hard
| > drive. I cannot, however, access either of them,
| > receiving fol error msg: "procedure entry point couldn't
| > be located in the dynamic link library fpcutl.dll."
| > Obviously, my installation of 2003 created a path
| > problem. How can I fix it so that I can access either
| > version of FP? I did a search for that .dll file and
| > found that the earlier version is in
| > c:\ProgramFiles\MicrosoftOffice\Office and the later
| > version in c:\ProgramFiles\MicrosoftOffice\Office11.
|
|
| i have the same prob. fp 2003 will not load...anybody from MS watching????