Public variable

[Eric]

Hello,

I am setting up a public variable in the declaration section of my module
(Public Authorized_Machine as string)
I initialize the variable right in the Auto_open() sub expecting ths
variable and its value to be available to all the procedures in my module,
but it does not work.
A simple "MsgBox Authorized_Machine" (in a seperate procedure) shows the
variable empty...

What am I doing wrong?

Thank you.

Eric

 

[Leith Ross]

Hello,

I am setting up a public variable in the declaration section of my module
(Public Authorized_Machine as string)
I initialize the variable right in the Auto_open() sub expecting ths
variable and its value to be available to all the procedures in my module,
but it does not work.
A simple "MsgBox Authorized_Machine" (in a seperate procedure) shows the
variable empty...

What am I doing wrong?

Thank you.

Eric

Hello Eric,
The Autpen, Auto_Close, Auto_Activate, and Auto_Deactivate macros
are provided for backward compatability. You should be using
Workbook_Open instead of Autpen. Place your Public varaiable in the
Declarations section of ThisWorkbook and placce your Autpen code
in the Workbook_Open procedure.

Sincerely,
Leith Ross

 

[Jim Cone]

Eric,
1. An Autpen sub must be in a standard module, not in the
ThisWorkbook module or a sheet module.
2. If you are opening the workbook using code then any Auto_xxx
subs will not run. Your have to use the RunAutoMacros method.
3. The public declaration of the variable should be in standard module.
4. The Workbook_Open event sub could also be used to initialize the variable.
--
Jim Cone
San Francisco, USA
http://www.realezsites.com/bus/primitivesoftware



"Eric" <[email protected]>
wrote in message
Hello,
I am setting up a public variable in the declaration section of my module
(Public Authorized_Machine as string)
I initialize the variable right in the Auto_open() sub expecting ths
variable and its value to be available to all the procedures in my module,
but it does not work.
A simple "MsgBox Authorized_Machine" (in a seperate procedure) shows the
variable empty...
What am I doing wrong?
Thank you.
Eric

 

[Gary Keramidas]

i don't have any luck when i have this in thisworkbook:
Option Explicit
Public RptFlag As Boolean
Public cnt As Long
Public iRow As Long
Public iMonth As Long
Public eMonth As Long

fails to compile because it says the variables aren't defined.

 

[Eric]

Thank you Leith.

Hello Eric,
The Autpen, Auto_Close, Auto_Activate, and Auto_Deactivate macros
are provided for backward compatability. You should be using
Workbook_Open instead of Autpen. Place your Public varaiable in the
Declarations section of ThisWorkbook and placce your Autpen code
in the Workbook_Open procedure.

Sincerely,
Leith Ross

 

[Eric]

Thanks Jim, I got it to work...

 

[Eric]

I had this too...

Eric

i don't have any luck when i have this in thisworkbook:
Option Explicit
Public RptFlag As Boolean
Public cnt As Long
Public iRow As Long
Public iMonth As Long
Public eMonth As Long

fails to compile because it says the variables aren't defined.

 

[Bob Phillips]

Should be in a standard module, not ThisWorkbook.

--
---
HTH

Bob

(there's no email, no snail mail, but somewhere should be gmail in my addy)